Worldwide Air Delivery
|
|
O'Nite Delivery
|
|
|
Compact 2.4 GHz 4 Channel Video & Stereo Audio Receiver * Manual Selection * Automatic Sequential Switching * SMA Antenna connector.Fully self contained only requires Power supply & Antenna, 1.5 metre AV Cable included.Cat Code: REG12-1.3 (1.3 x 3.8 Plug) Plug Pack $12Cat Code: Cable-3813/L $3 (1.3 x 3.8 Plug on figure 8 cable)
Pictured with optional Ant-Stub Antenna, Ant-W5dB or higher Gain recommended for best results. |
Applications:
Business
Observe showrooms, warehouse, offices, doors, etc without the need to install
expensive and inflexible wiring
Receive images to multiple remote Monitors (VCR) for training, presentation or
general surveillance and observation
View images from Satellite TV, Pay TV, Cable TV, DVDs, VCRs, Computers, Cameras,
Quads, Multiplexers, etc in multiple rooms from one source without distribution
amplifiers or wiring.
Distribute your message/commercial to multiple TVs / Monitors in showrooms,
tradeshows, etc without wires.
Entertainment
View & Listen all over the house and even out on the patio or pool area from a
central source.
Enjoy Satellite TV, rented tapes and DVDs in every room of the house without
expensive wiring
Safety
See who is outside your door using a Video Camera, Transmitter and your regular
TV.
Monitor your baby, your children, the swimming pool, the elderly, ill or
recuperating using your Camcorder or a CCTV Video Camera & Transmitter.
Observe your home or office using up to four transmitters and cameras (in
Australia maximum is two transmitters).
Features:
TV System: Suits ALL TV Systems in ALL
Countries, operation is independent of TV System.
Four Channel Receiver, single channel selection or Automatic Sequential
Switching with ~ 4 second dwell.
Built-in P.L.L. circuit
Specifications:
ISM Band: 2.4 ~ 2.483 GHz, 4 channels
Antenna Input: SMA Female Socket, 50 ohms impedance
Demodulation Method: FM
Oscillator: P.L.L. (Phase Locked Loop)
Video Output: Standard Composite Video 1 v p-p, 75 ohm impedance via 2.5 mm mini
socket & 1.5 metre cable with RCA Plug, compatible with CCIR, PAL, EIA, NTSC,
SECAM TV Systems.
Audio Output: Line Level, via 2.5 mm mini socket & 1.5 metre cable with RCA
Plugs.
Receiver:
Power Supply Requirement: 9 ~ 12 VDC,
1.3 mm x 3.8 mm DC socket, center pin = (+).
Current: ~ 180 mA @ 10.5 Volts.
Sensitivity: -92 dbm.
Dimensions: ~ 52 mm (W) 60 mm (H) 20 mm (D) excluding sockets & antenna. ~ 40
grams.
This device will be affected by other devices that operate on or near the same
frequency.
Connection info: here
Audio & Video Output for:
DVD Player, Satellite TV, Reversing Video Camera, Tuner, Camcorder, Surveillance Video Camera, PC DVD / MPEG / AVI Playback, TV Set (AV), Switcher, Video Monitor, PC Audio/Video Capture Card, VCR, DVR, etc.
Manufacturer's Experience: 10 + Years ISO 9001 Certified, made in Taiwan.
Compatibility:
Receives transmissions from: TX-Mini, TX-Box, TX/RX AV System II, TX/RX-AV3, TX-MOD 2, TX-MOD 3, TX-ELECTRET, TX-BNC, TX-AV050, TX-AV500, TX-AV1000, TX-AV2000, TX-CAM2 & TX-CAM3.
ANTENNAS
Range and Signal to Noise Ratio (SNR) may be improved by increasing gain of antenna on Receiver and/or Transmitter. For maximum signal transfer TX and RX antennas should be the same polarity, that is both oriented Vertically or Horizontally.
|
Parabolic Yagi & Flat are directional antennas. Whip antennas when used vertically are for most practical purposes omni or non directional.To maximise 'Range' minimise the length of Coax Cable between Antenna and TX/RX. |
|
Antenna Gain... what does it mean ??? a simplified explanation Received signal strength from an antenna with 3 dBi gain will be double that from an antenna that has 0 dBi gain, received signal strength from a 6 dBi will be double that from a 3 dBi and so on... An increase in antenna gain of 3 dBi is approximately equal to doubling the transmitter output, received signal strength or range can be increased by raising antenna gain or transmitter output. Range can be doubled by either increasing antenna gain by 6 dBi or quadrupling the transmitter output. The maximum allowed 2.4 GHz LIPD Video Transmitter output power is 10 milliwatts (mW) EIRP (in Australia), increasing transmitter output is illegal and therefore not an option. Increasing the gain of the
receiver antenna is an alternative to increasing transmitter output. |
|
* LIPD = Low Interference
Potential Devices. * EIRP = Equivalent Isotropically Radiated Power.
Source: Australian Communications Authority |
** Information plagiarised from this page may be found on 'copy-cat' Web Sites **
Use your Browser "Back Button" to return to previous page