CCTV Video & Audio 6" MONOCHROME VIDEO - AUDIO SURVEILLANCE MONITOR
with 2.4 GHz Receiver - Video & Audio Inputs - VCR Outputs, lightweight
Plastic Case. Suitable for Wired & Wireless Video Cameras, Switchers,
Multiplexers, etc etc. DC powered. Use with a single Wired or Wireless Video
Camera for an INSTANT low-cost yet effective Closed Circuit Television System.
Cat Code: MON/RX
6
MONOCHROME 6 Inch VIDEO /
AUDIO MONITOR with inbuilt 2.4 GHz RECEIVER & VCR I/O
Whip Antenna
$15
Whip Antenna Folding
$20
Flat
Antenna
$15
Yagi-8 Antenna (Gold
?) (A) $99 / (B)
$119
Yagi-12 Antenna (Gold
?) (A) $119 / (B)
$139
Yagi-15 Antenna (Gold
?) (A) $149 / (B)
$169
Para-18 Antenna (Gold
?) (A) $89 / (B)
$99
Para-21 Antenna (Gold
?) (A) $109 / (B)
$129
Para-24 Antenna (Gold
?) (A) $149 / (B)
$169
23 cm RG-316 Coax Ext Cable SMA male to SMA female $25
50 cm RG-316 Coax Ext Cable SMA male to SMA female $35
5 metre RG-316 Coax Ext Cable SMA male to SMA female $79
4.5 metre RG-223 Coax Ext Cable SMA male to SMA female $89
SMA male to N female Adaptor to suit Para Antennas $10
SMA male to TNC female Adaptor $10
~ 700 Lines Horizontal Resolution (center). Sensitivity 0.5 to 2.0 v p-p, Negative Sync.
Composite Video Input and Output for CCIR or EIA 75 ohm, compatible with
Australian and USA TV standards.
Line Level Audio Inputs and Output 1 v p-p, 10 000 ohm impedance.
Wireless or Wired input Selection for VCR Playback or Video from a Wired Camera
/ Switcher, Multiplexer, etc.
Outputs for VCR Recording or other purposes.
INPUTS
Wireless: Antenna via female SMA socket at top left back of Case.
Wired: Video and Audio via RCA sockets at rear of Case.
Power Supply: 15 ~ 18 VDC, ~ 1.2 Amps, via 2.1 x 5.5 mm socket at rear of case -
center pin = (+). An optional 12 VDC 1.5 Amp unregulated Plug Pack is available.
OUTPUTS Video and Audio for VCR, etc, via RCA sockets at rear of Case.
CONTROLS
Front: On/Off push-button Power Switch. Vertical Hold, Brightness and Contrast
under hinged Panel.
Left Side: Sliding Volume Control.
Rear: 50Hz (CCIR, Australia) / 60Hz (EIA, USA) switch. Wired / Wireless input
switch. Channel 1, 2, 3 or 4 select switches.
RECEIVER 2.4 ~ 2.483 GHz, 4 channel, Single Channel selection or Automatic Sequential
Switching with ~ 4 second dwell. Video compatible with TX-MOD 1, TX-MOD 2, TX-MOD 3, TX-ELECTRET,
TX-BNC, HI-POWER TX, TX-CAM IR, TX-CAM, TX-CAM2, TX-CAM2P, TX-RX KitSet V2,
TX/RX AV System and TX/RX AV System II. Audio compatibility varies and cannot be guaranteed, audio reception may
be fine with some transmitters but not with others.
SMA female Antenna socket, 50 ohms impedance at top left back of Case.
Sensitivity -92 dbm.
~ 150 mm (W) ~ 142 mm (H) ~ 190 mm (D)
Weight ~ 1.3 kilograms (~ 3.5 kg³ shipping volume)
Plug-In
DIY AV 20 metre Cable / Adaptor Set: 20 metre AV Cable with moulded
Plugs & Socket. Two RCA Plugs & DC Plug for Camera end. Two RCA Plugs
for Monitor & DC Socket for Camera Plug-Pack. One BNC-RCA Adaptor for
Camera, VCR, Quad, Switcher, Multiplexer, Monitor, Transmitter, etc.
Wireless
Equipment Menu